DMD - not lighting up

View previous topic View next topic Go down

DMD - not lighting up

Post by madmanc on Sat Nov 12, 2016 12:19 am

Fired up the stargate after an extended period of time (3-4 months) and the DMD is blank, the last time it was used it was perfect.

I have pulled off the cables and reconnected them, no change.

Any ideas appreciated.

madmanc

Posts : 18
Join date : 2013-06-04

Back to top Go down

Re: DMD - not lighting up

Post by prock on Mon Nov 21, 2016 2:06 pm

Sounds like a fuse to me. If one is bad and it keeps blowing after that there is a bigger issue. If not you'll need to start checking voltages. Could be the DMD so you might want to swap it out and see.
avatar
prock

Posts : 720
Join date : 2012-06-30
Location : Winnipeg

Back to top Go down

Re: DMD - not lighting up

Post by prock on Mon Nov 21, 2016 2:12 pm

For reference: http://www.pinrepair.com/sys3/

The fuse you need to check is probably F3. Be sure to replace it with a proper spec fuse if it is bad.
avatar
prock

Posts : 720
Join date : 2012-06-30
Location : Winnipeg

Back to top Go down

Re: DMD - not lighting up

Post by Sponsored content


Sponsored content


Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum